Concrete Driveways & Sidewalks in Milton, WA

A driveway in Milton is partly a city project. The apron and approach sit in public right-of-way, and the city’s public works standards set width, grade, and surfacing limits. We lay the pour out around those numbers before anything is formed.

Driveway cross-sectionA concrete slab with reinforcement and a control joint sits on a compacted crushed-rock base, sloped so water runs off the surface. 51234
Typical driveway section: built from the base up
  1. Broom-finished slab, about 4 inches thick for a typical driveway
  2. Reinforcement sized to the loads
  3. Control joint, where cracking is meant to happen
  4. Compacted crushed-rock base
  5. Surface slopes so water leaves the slab

Driveways & sidewalks in Milton: what to know

Milton’s published public works standards put numbers on driveways. A residential driveway is capped at 20 feet wide, or 30 feet for a three-car garage if the Public Works Director approves. Grade is limited to 12 percent unless the director allows otherwise, the driveway must meet the street at 60 degrees or more, and the apron cannot extend past the face of the curb. Runs over 150 feet need the fire marshal’s approval too.

The zoning code adds its own limits. Driveways count toward the impervious surface cap for your zone, a single-family home needs two off-street spaces, and a clear sight triangle has to stay open at the driveway mouth. If you are adding an accessory dwelling unit, its parking is counted per bedroom unless transit is close.

Permits and rules in Milton

Driveway work on your own lot is reviewed by the City of Milton’s planning and community development staff. Anything in the public right-of-way, including the approach, apron, curb, and sidewalk, needs a separate street work permit from Public Works, and the owner is expected to maintain the approach afterward. The city’s standards bar monolithic curb, gutter, and sidewalk pours and call for an inspection of forms and subgrade first. We check Milton’s apron and approach rules before a driveway goes on the schedule.

Rules change and vary by parcel, so we confirm the current requirements with the city before we start.

How we approach it

  • Measure width, grade, and approach angle against Milton’s driveway limits before we form
  • Mark the sight triangle at the driveway mouth so walls and plantings stay clear
  • Dig out soft spots and build a compacted crushed-rock base before any pour
  • Schedule right-of-way work around the city’s permit and inspection steps

For the full process, see our Concrete Driveways & Sidewalks page.

Building in the cold months? See our guide to winter concrete pours.

Our driveways & sidewalks work, serving Milton

Examples of our work. We build driveways & sidewalks in Milton and the cities around it. See all of our work

Questions from Milton homeowners

How wide can I make my driveway in Milton?

The public works standards cap a residential driveway at 20 feet, with 30 allowed for a three-car garage if the director approves. Impervious surface limits also count, so a wider driveway can use up room you may want for a patio. We check both before we draw it.

Do I need a permit to replace my sidewalk apron in Milton?

The apron sits in public right-of-way, so replacing it needs city approval, and the city inspects forms and subgrade before the pour. We ask the city which permits apply and tell you before we quote.

My Milton driveway is steep. Is there a grade limit?

The public works standards set a maximum grade of 12 percent unless the Public Works Director approves a different grade in writing. We measure the existing grade first and see what the city would accept.

Other work in Milton

The same service nearby

Talk to us about your project

Call or email us. We’ll talk through the work and set up a time to see the site.

Call 206-483-5334Get a quote